USRobotics NETServer/16 Manual de usuario descargar pdf (Pagina 111)

Talking to the Modems 7-7

Caution: Avoid using commands that write to the modem’s

NVRAM (such as &W) in an initialization script that you plan to

use indefinitely. Rewriting the NVRAM every time the port is

reset may eventually wear the NVRAM out. Use such com-

mands only on a short term basis.

The following special characters are allowed. \r should always

be present at the end of any modem initialization string:

\r carriage return

\n line feed

\0xx octal digit in the xx

\\ single backslash

Use an Existing Initialization Script

A port is not sent any script until an existing script is assigned to

it. Type the following command:

set s<port #> init <script name >

The script must already exist and should be assigned some sort

of content string. You can also remove an init script from a port.

Type the following command to configure a port to use no init

script:

set s<port #> init none

Delete an Initialization Script

An initialization script may be deleted using the following

command:

delete init <script name>

Displaying an Initialization Script

To display a specific initialization script, use the following

command:

show init <script name>

If a script name is not specified, all initialization scripts will be

displayed.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 283 284

Sin comentarios

USRobotics NETServer/16 Manual de usuario Pagina 111