Usrobotics V.34 Manual de usuario descargar pdf (Pagina 156)

COURIER HIGH SPEED MODEMS

D-14 Remote Access

When you make remote configuration changes, the remote

prompt is altered to indicate that changes have been made. The

prompt will change from:

Remote->

Remote+>

If you restore the original configuration (with %C1, explained

next), the original prompt is also restored (back to Remote->),

indicating that the original configuration is intact.

By default, configuration changes do not take effect until the

connection is terminated (see %Cn). However, the new configu-

ration is immediately reflected on the information screens

(ATIn).

Remote Configuration Commands

There are some additional commands that are only executable

during a remote access session. These commands are as

follows.

%Bn Configure the Courier's serial port rate.

%B0 110 bps %B6 9600 bps

%B1 300 bps %B7 19,200 bps

%B2 600 bps %B8 38,400 bps

%B3 1200 bps %B9 57,600 bps

%B4 2400 bps %B10 115,200 bps

%B5 4800 bps

%Cn Configuration control.

%C0 Defer configuration. This is the default. Configu-

ration changes are deferred until the call is ended;

they take effect for ensuing connections. You do

not need to enter this command; it is the default

unless you enter %C1 or %C2.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 244 245

Sin comentarios

Usrobotics V.34 Manual de usuario Pagina 156